2021 Kuhns Mfg LLC Tie-Grabber KN510

2021 Kuhns Mfg LLC Tie-Grabber KN510

Features may include:

• The low weight requirement for the grabber allows for the usage of a smaller loader.

• If your bales are 36" long, you can cross stack the bales with the KN510 or 510 grabber.

• The 1034 bale group can be picked up from any side of the group.

• Working dimensions are inside the frame where bundles are carried but the bundles can vary in width and length.

HIGH QUALITY KNOTTER

• Quality hand built and tested knotter that consistently makes cleaner, tighter knots.

TWIN BALL TWINE BOX

• Enough room for two balls of twine gives you all day performance. Easy to access and weather proof.

SOLID CAST GRABBING HOOKS

• Wear resistant. In the rare event that you should break a hook, they are easy to replace with essentially no down time.

HOW THE ACCUMULATOR WORKS:

The primary hydraulic circuit operates the bale squeeze and the bale hooks. When activated, the squeeze bar pulls the bales in. A sequence valve then automatically activates the bale hooks. The secondary hydraulic circuit operates the twine arm and the knotter. The twine arm starts on the right-hand side, and when it completes its rotation, a valve automatically diverts the flow to the knotter.

In Detail:

With the squeeze arm out and the twine arm on the right-hand side, the operator will align the left side of the Tie-Grabber with the left side of the group of bales on the ground and push the group forward to compact the group. The angle of the squeeze arm will pull the bales in as it moves forward. When the bales are compacted length wise, the operator will activate the primary hydraulic circuit. This will pull the squeeze arm in, compacting the bales sideways. The bale hooks will automatically begin to set, so the operator needs to make sure the Tie-Grabber is firmly set on the group so the hooks can set properly. With the bales properly secured, the operator can safely lift and move the group.

While traveling with the loaded Tie-Grabber, the operator will activate the secondary hydraulic circuit. The twine arm then rotates to the left side for the twine to be tied securely with the Rasspe knotter. When that is finished, the hay is ready to be deposited. When traveling to the next group the operator can return the twine arm to the right-hand side.